彩经网

技术中心
Technology Center
当前位置:网站彩经网 > 技术中心 > 技术详情
使用注意事项
2017-06-16 16:28

棚板在运输和储存时,就保持直立置放禁止叠放.在任何情况下应保持棚板干燥.

本厂棚板表面喷涂的白色涂料经烧结后,正常可使用3-6个月,如表面白色涂料需更换,可使用本厂调配的涂料,在喷涂前尽可能将旧涂料面清除干净后,再以喷枪喷刷施工,厚度为0.4-0.6mm为宜.

喷涂施工后的棚板,必需待其完全干燥后,方可使用.

坯体置于棚板上,需特别注意坯体需完全干燥,产品底部接触棚板部分,就将釉料擦拭干净,以免粘瓷.

台车装载时,耐火柱宜保持一直线,以免因支撑点不同,而影响棚板的寿命.

台车装载时棚板与棚板之间的距离,视坯体高度给予保留适当空隙,10-20mm为宜,坯与坯之间也需保留适当间隙,不可挤在一起或集中在某处,使窑内燃烧的火焰及空气对流更加顺畅.

棚板正常使用时切忌急速冷及急速热升温,以免棚板龟裂,因此在烧成时间及温度的设定应特别注意.

用户在使用过程中如有疑问,请及时与我们或供应商联系,我们良好的售后服务一定会使您满意.

 

Please keep shack plate vertical during transportation and storage ,and keep it dry at any time.

 

The calcined white coating on shack plate is offective for 3-6 months.pleaseuse the coating specially made up by our factory if coating replacement is needed.remember to clear old coating completely,and then paint in thickness of 0.4-0.6mm with spraygun.

 

Nowly painted shack plate can not be used untilit is completely dry.

 

When embryo is placed on shack place ,be careful to keep embryo dry.when produce bottom contacts shack plate ,please clear glaze off to avoid glaze strickiness.

 

During installation,fire-resisting colunm should be in straight ling because inconsistent supporting points shorten shack plate’s  life.

 

During installation,appropriate space should be kept between shack plates ,preferably10mm-20mm,approriate space should also be kept between embryse so sa to keep fire buring more completely and air comvection more smoothly in kiln.

 

Shack plate can never be cooled or heated quickly ,otherwise shack plate will be splitted, thus special attention should be paid to temperature and product  completion.

 

Please contact your supplier or the factory for any questions .our after sale service shall definitely satisfy you.

产品推荐 Product recommend